Frequency Interfrenece Keeps Opening And Closing Garage Door

There may also be loose wire connections inside the button housing itself.

Frequency interfrenece keeps opening and closing garage door.

Garage doors operate using frequencies between 28 and 360 mhz. Of course your garage door opener could be receiving interference due to a range of sources and it s not always possible to diagnose interference and pinpoint what s going on. Garage doors use radio frequencies to open and close. As these wires short against the housing the electrical impulse causes the door opener to activate.

The location of the garage door openers signal may be blocked by some of the other devices in your home running on the same frequency. Below are three reasons why your garage door opens on its own and some quick fixes you can try. Garage door openers operate by using radio waves similar to how a remote controlled car works. The symptom of this is a garage door that is in constant motion opening fully then immediately descending only to start the same cycle again.

Turning your antenna in the opposite direction of high frequency signals can divert unwanted interference from disturbing the frequency of your garage door opener which in turn can improve its operating ability. Surprisingly changing remotes can prevent this inconvenience. Locating and adjusting the antenna inside of your garage can change the frequency on your garage door remote. However if there is a new frequency then you may need to speak to a garage door repair service to relocate your receiver or fit a plastic casing.